FIELDCALC · ENGINEERING TOOLS
Motor and machinery calculators and guides
Calculate reduction ratios, pulley speeds, motor torque and power conversions. Compare conditions and understand formulas with worked examples.
What would you like to calculate?
Gear ratio · output RPM
Calculate output speed and compare reduction ratios.
Open calculator →Pulley speed
Distinguish driver and driven effective diameters and compare speeds.
Open calculator →Motor torque
Calculate torque from mechanical shaft power and speed, with operating limits explained.
Open calculator →kW · hp · PS conversion
Convert both ways and distinguish mechanical hp from metric PS.
Open calculator →Cylinder force calculator
Calculate theoretical extension and retraction force for a single-rod double-acting cylinder from pressure, bore and rod diameter. SI and US inputs; N, kgf and lbf results.
Open calculator →RPM and feed speed calculator
Calculate ball screw linear feed from motor RPM, lead and reduction ratio, or work backward from target feed to motor RPM. Compare mm/min, mm/s, in/min and ideal travel time.
Open calculator →US wire size review
Compare US copper AWG/kcmil candidates under the stated NEC 2023 reference conditions.
→Pump flow & head calculator
Convert flow units and water-equivalent head / pressure, and compare flow, head and shaft power at different speeds for the same centrifugal pump.
Open calculator →Understand the result
- Reduction ratios and output speed
- How pulley diameter changes speed
- Calculate torque from kW and RPM
- Why hp and PS give different answers
Choose the right input values
Check rated mechanical shaft power and speed, reducer ratio and pulley pitch or effective diameters. Mixing rated and measured values can change the interpretation. Read the example assumptions and use values from a consistent operating point.
Scope and calculation basis
These tools support preliminary checks. Efficiency, slip, acceleration, thermal conditions and equipment ratings need separate review. Comparison examples are illustrative assumptions, not measurements of specific machines.
Formulas, units, verification examples and error reporting →