▧ FieldCalcENGINEERING TOOLS
SMALL TOOLS. PRECISE CALCULATIONS.

Gear Ratio & RPM Calculator

Practical calculators for motors and machinery.
Built for your workbench, and your phone.

Free to useNo installationEnglish / 한국어

Gear Ratio & RPM Calculator

TOOLS 01—08

Calculate output RPM from input speed and reduction ratio.

YOUR RESULT
Formula & how it works
These tools provide basic calculations under ideal conditions. Check manufacturer specifications and losses when applying results.
1400 RPM input divided by a reduction ratio of 10 gives 140 RPM
Concept schematic, not a scale equipment drawing.

WORKED FIELD EXAMPLE · HYPOTHETICAL

Compare output speed before replacing a gearbox

Assume a motor running at 1,500 RPM with an existing reduction ratio of 30.

1. Enter the conditions

Enter motor speed 1,500 and ratio 30: output is 50 RPM. Change only the ratio to 50: output becomes 30 RPM.

2. Interpret the result

At the same motor speed, a different ratio changes output speed. The theoretical ratio for a 40 RPM target is 1,500 ÷ 40 = 37.5. Check available product ratios, rated torque and operating limits separately.

3. Check before applying

Before reducing the ratio to increase speed, verify the driven mechanism’s speed limit and torque requirement. This calculation does not determine gearbox service life.

How to use

Enter input RPM and the reduction factor. Enter 60 for a 1:60 reducer.

Worked example

1,750 RPM ÷ 60 = 29.1667 RPM

Application notes

A larger reduction factor lowers output speed. Check the gearbox rated input speed and permissible torque in its manufacturer specifications.

Workshop examples

Workshop example: conveyor reducer

For a motor at 1,500 RPM with a 30:1 reduction, enter 1500 and 30. Output speed is 1,500 ÷ 30 = 50 RPM. This is reducer shaft speed; conveyor travel speed also depends on roller diameter.

Workshop example: two reduction stages

A 5:1 stage followed by a 6:1 stage gives a total reduction of 5 × 6 = 30. An input of 1,800 RPM gives 60 RPM output. Check whether each stage reduces or increases speed.

Frequently asked questions

Should I enter 30:1 or 1:30?

Check the manufacturer’s ratio definition. If the input shaft turns 30 times for one output revolution, enter 30.

Can I use gear tooth counts?

For a single pair with 20 driver teeth and 60 driven teeth, the reduction is 60 ÷ 20 = 3. Enter 3. For compound trains, multiply the ratios for each stage.

Does torque increase by the same ratio?

Ideally yes, but actual output depends on transmission efficiency and the reducer torque rating. This speed calculator does not calculate output torque.

More calculators

Calculation guides

More calculation guides →